Imprimante3D/Outils/Drill_bit_sharpener_with_true_relief_angle_V2

.: :,
,:::::::: ::` ::: :::
,:::::::: ::` ::: :::
.,,:::,,, ::`.:, ... .. .:, .:. ..`... ..` .. .:, .. :: .::, .:,`
,:: ::::::: ::, ::::::: `:::::::.,:: ::: ::: .:::::: ::::: :::::: .::::::
,:: :::::::: ::, :::::::: ::::::::.,:: ::: ::: :::,:::, ::::: ::::::, ::::::::
,:: ::: ::: ::, ::: :::`::. :::.,:: ::,`::`::: ::: ::: `::,` ::: :::
,:: ::. ::: ::, ::` :::.:: ::.,:: :::::: ::::::::: ::` :::::: :::::::::
,:: ::. ::: ::, ::` :::.:: ::.,:: .::::: ::::::::: ::` :::::::::::::::
,:: ::. ::: ::, ::` ::: ::: `:::.,:: :::: :::` ,,, ::` .:: :::.::. ,,,
,:: ::. ::: ::, ::` ::: ::::::::.,:: :::: :::::::` ::` ::::::: :::::::.
,:: ::. ::: ::, ::` ::: :::::::`,:: ::. :::::` ::` :::::: :::::.
::, ,:: ``
::::::::
::::::
`,,`


http://www.thingiverse.com/thing:3059363
Drill bit sharpener with true relief angle V2 by michalovis is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

Update 2018/10/08

####V2.00
After several tests, I found that to improve the relief angle, you have to bring the pivot point as close as possible to the sharpening stone.
Then I modeled an improved version (V2).
Be careful not to burn the material because the drill is very close and heats up quickly.

Printed in ABS - 0.1mm - Infill 40%



####V1.00
https://youtu.be/f-khFlEaKE0
This is a remix from MGX tool.

When you turn the drill to give it the relief angle, you should push it slightly upwards

A drill holder with smaller slot was added for little drills. (I have thick fingers and I could not hold them)

Needs to add:

M3x8 allen bolt
M3 nut.

# Print Settings

Printer: FlyingBear p905x
Rafts: No
Supports: No
Resolution: 0.1
Infill: 40%