| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455 |
- .: :,
- ,:::::::: ::` ::: :::
- ,:::::::: ::` ::: :::
- .,,:::,,, ::`.:, ... .. .:, .:. ..`... ..` .. .:, .. :: .::, .:,`
- ,:: ::::::: ::, ::::::: `:::::::.,:: ::: ::: .:::::: ::::: :::::: .::::::
- ,:: :::::::: ::, :::::::: ::::::::.,:: ::: ::: :::,:::, ::::: ::::::, ::::::::
- ,:: ::: ::: ::, ::: :::`::. :::.,:: ::,`::`::: ::: ::: `::,` ::: :::
- ,:: ::. ::: ::, ::` :::.:: ::.,:: :::::: ::::::::: ::` :::::: :::::::::
- ,:: ::. ::: ::, ::` :::.:: ::.,:: .::::: ::::::::: ::` :::::::::::::::
- ,:: ::. ::: ::, ::` ::: ::: `:::.,:: :::: :::` ,,, ::` .:: :::.::. ,,,
- ,:: ::. ::: ::, ::` ::: ::::::::.,:: :::: :::::::` ::` ::::::: :::::::.
- ,:: ::. ::: ::, ::` ::: :::::::`,:: ::. :::::` ::` :::::: :::::.
- ::, ,:: ``
- ::::::::
- ::::::
- `,,`
- http://www.thingiverse.com/thing:3059363
- Drill bit sharpener with true relief angle V2 by michalovis is licensed under the Creative Commons - Attribution - Non-Commercial license.
- http://creativecommons.org/licenses/by-nc/3.0/
- # Summary
- Update 2018/10/08
- ####V2.00
- After several tests, I found that to improve the relief angle, you have to bring the pivot point as close as possible to the sharpening stone.
- Then I modeled an improved version (V2).
- Be careful not to burn the material because the drill is very close and heats up quickly.
- Printed in ABS - 0.1mm - Infill 40%
- ####V1.00
- https://youtu.be/f-khFlEaKE0
- This is a remix from MGX tool.
- When you turn the drill to give it the relief angle, you should push it slightly upwards
- A drill holder with smaller slot was added for little drills. (I have thick fingers and I could not hold them)
- Needs to add:
- M3x8 allen bolt
- M3 nut.
- # Print Settings
- Printer: FlyingBear p905x
- Rafts: No
- Supports: No
- Resolution: 0.1
- Infill: 40%
|
