Imprimante3D/Piece Imprimante/Adjustable_Belt_Tensioner_Tightener_and_Belt_Tie_Tevo_Tarantula

.: :,
,:::::::: ::` ::: :::
,:::::::: ::` ::: :::
.,,:::,,, ::`.:, ... .. .:, .:. ..`... ..` .. .:, .. :: .::, .:,`
,:: ::::::: ::, ::::::: `:::::::.,:: ::: ::: .:::::: ::::: :::::: .::::::
,:: :::::::: ::, :::::::: ::::::::.,:: ::: ::: :::,:::, ::::: ::::::, ::::::::
,:: ::: ::: ::, ::: :::`::. :::.,:: ::,`::`::: ::: ::: `::,` ::: :::
,:: ::. ::: ::, ::` :::.:: ::.,:: :::::: ::::::::: ::` :::::: :::::::::
,:: ::. ::: ::, ::` :::.:: ::.,:: .::::: ::::::::: ::` :::::::::::::::
,:: ::. ::: ::, ::` ::: ::: `:::.,:: :::: :::` ,,, ::` .:: :::.::. ,,,
,:: ::. ::: ::, ::` ::: ::::::::.,:: :::: :::::::` ::` ::::::: :::::::.
,:: ::. ::: ::, ::` ::: :::::::`,:: ::. :::::` ::` :::::: :::::.
::, ,:: ``
::::::::
::::::
`,,`


https://www.thingiverse.com/thing:1780636
Adjustable Belt Tensioner/Tightener and Belt Tie (Tevo Tarantula) by supasorn is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

A simple, adjustable belt tensioner + a belt tie to replace the cable tie.
The tensioner requires an M3 screw. The screw hole is tight-fit and should provide more than enough tension to hold the screw. Designed to be printed at 100% scale.

Use higher wall line count (shells) & high infill for maximum strength.

The calibration cube in 3rd photo was printed @0.1mm layer height with *properly* tensioned belts and a Dual Z mod https://www.thingiverse.com/thing:2163949

sketchup/fusion360 file is attached in case adjustment is needed.

**Update 3/11/17 : New hole, added fillet.
**Update 10/23/16 : increased thickness for screw holder and legs.

# Print Settings

Rafts: No
Supports: No
Resolution: 0.2
Infill: 50%