Imprimante3D/Piece Imprimante/Piece/Semi-Circular_Anet_A8_Fan_Duct

.: :,
,:::::::: ::` ::: :::
,:::::::: ::` ::: :::
.,,:::,,, ::`.:, ... .. .:, .:. ..`... ..` .. .:, .. :: .::, .:,`
,:: ::::::: ::, ::::::: `:::::::.,:: ::: ::: .:::::: ::::: :::::: .::::::
,:: :::::::: ::, :::::::: ::::::::.,:: ::: ::: :::,:::, ::::: ::::::, ::::::::
,:: ::: ::: ::, ::: :::`::. :::.,:: ::,`::`::: ::: ::: `::,` ::: :::
,:: ::. ::: ::, ::` :::.:: ::.,:: :::::: ::::::::: ::` :::::: :::::::::
,:: ::. ::: ::, ::` :::.:: ::.,:: .::::: ::::::::: ::` :::::::::::::::
,:: ::. ::: ::, ::` ::: ::: `:::.,:: :::: :::` ,,, ::` .:: :::.::. ,,,
,:: ::. ::: ::, ::` ::: ::::::::.,:: :::: :::::::` ::` ::::::: :::::::.
,:: ::. ::: ::, ::` ::: :::::::`,:: ::. :::::` ::` :::::: :::::.
::, ,:: ``
::::::::
::::::
`,,`


https://www.thingiverse.com/thing:1954001
Semi-Circular Anet A8 Fan Duct by lokster is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

### If you use this fan duct & think it makes your prints look better, don't forget to TIP! ;)

This is my version of the "circular fan duct" for the Anet A8 printer (and other compatible printers).
Highlights:
- it's actually semi-circular. The circular one deforms after a while if printed in PLA (and I use/have only PLA), so I designed this version.
- it snaps to the fan a lot more securely (on the outside of the fan), and there is no chance of falling off during print.
- designed in such way, that the air blows just below the tip of the nozzle. The original design was blowing too far down.

Designed in Blender, by heavily modifying http://www.thingiverse.com/thing:1874390 - simplifying the mesh, adding the new attachment part etc.

Note: there is newer, and more effective fan duct I designed: http://www.thingiverse.com/thing:2133328

# Print Settings

Printer: Anet A8
Rafts: No
Supports: No
Resolution: 0.2