| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051 |
- .: :,
- ,:::::::: ::` ::: :::
- ,:::::::: ::` ::: :::
- .,,:::,,, ::`.:, ... .. .:, .:. ..`... ..` .. .:, .. :: .::, .:,`
- ,:: ::::::: ::, ::::::: `:::::::.,:: ::: ::: .:::::: ::::: :::::: .::::::
- ,:: :::::::: ::, :::::::: ::::::::.,:: ::: ::: :::,:::, ::::: ::::::, ::::::::
- ,:: ::: ::: ::, ::: :::`::. :::.,:: ::,`::`::: ::: ::: `::,` ::: :::
- ,:: ::. ::: ::, ::` :::.:: ::.,:: :::::: ::::::::: ::` :::::: :::::::::
- ,:: ::. ::: ::, ::` :::.:: ::.,:: .::::: ::::::::: ::` :::::::::::::::
- ,:: ::. ::: ::, ::` ::: ::: `:::.,:: :::: :::` ,,, ::` .:: :::.::. ,,,
- ,:: ::. ::: ::, ::` ::: ::::::::.,:: :::: :::::::` ::` ::::::: :::::::.
- ,:: ::. ::: ::, ::` ::: :::::::`,:: ::. :::::` ::` :::::: :::::.
- ::, ,:: ``
- ::::::::
- ::::::
- `,,`
- http://www.thingiverse.com/thing:2146021
- Anet A8 Bowden Extruder Mount by Brogz007 is licensed under the Creative Commons - Attribution license.
- http://creativecommons.org/licenses/by/3.0/
- # Summary
- Tidier and very sturdy mount for a Bowden extruder. Designed specifically for Anet A8. Lines up nicely with your hot end too.
- Requires:
- 2 M3x25
- 1 M3x20
- The two original M3x18 from the Anet A8 frame
- The toothed wheel should be brought forward by 5mm with the smallest supplied allen key.
- The centre hole is 24mm wide so up to you if you use supports.
- I print nearly all my parts in 50% density so again up to you what your preferred infill is.
- Printed in PLA so 'as is' 100% scale in Cura
- Edit: Added left side mount.
- Edit: Added original 123D file for remixing
- Caution for US users:
- The bowden fitting for original and clone E3Dv6's seems to be an imperial larger fitting and will not fit. The correct fitting is a PC4-M6.
- # Print Settings
- Printer: Anet A8
- Rafts: No
- Supports: Yes
- Resolution: 0.2
- Infill: 50
|
